Siemens SCALANCE XM-400 Configuration Manual page 443

Syntax
Call up the command with the following parameters:
show ip ospf
[area-id]
database
[link-state-id]
[{
}]
The parameters have the following meaning:
Parameter
area-id
asbr-summary
external
network
nssa-external
router
summary
link-state-id
adv-router
ip-address
self-originate
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
{
asbr-summary|external|network|
nssa-external|router|summary
}
adv-router <ip-address>|self-originate
Description
Area-ID
only shows information of the LSA type
ASPR (Autonomous System Border
Router). (Type 4)
only shows information of the LSA type
"External" (Type 5)
only shows information of the LSA type
"Network" (Type 2)
only shows information of the LSA type
"NSSA (Not so stubby area) External"
(Type 7)
only shows information of the LSA type
"Router" (Type 1)
only shows information of the LSA type
"Summary" (Type 3)
ID of the LSA .
Link State ID depends on the LSA
type.
Keyword for the router-specific LSA
shows the router-specific LSA for a
specific IP address
Number of LSAs generated by the local
router
Layer 3 functions
9.2 OSPFv2 (IPv4)
Range of values / note
specify an ID.
x.x.x.x
x = 0 ... 255
0.0.0.0 = backbone area.
-
-
-
-
-
-
Link State ID consists of 4 num-
bers each between 0 and 255
-
specify a valid IP address.
If no IP address is entered, the
specific LSAs of the local router
are displayed.
-
443