Gvrp - Siemens SCALANCE XM-400 Configuration Manual

Layer 2 management protocols
8.1 GARP
Further notes
If you want to enable the function for a specific interface on the device, use the
command.
You can display the status of this function and other information with the
info
8.1.2.3

gvrp

Description
With this command, you enable the GVRP function for all or individual interfaces on the
device.
Requirement
You are in the Global configuration mode
or
You are in the Interface configuration mode
The command prompt is as follows:
cli(config)#
cli (config-if-$$$) #
Syntax
Call the command without parameters:
gvrp
Result
In the Global configuration mode: The GVRP function is enabled on the device.
In the Interface configuration mode: The GVRP function is enabled for this interface.
Further notes
If you have enabled the GARP module, you start GVRP explicitly with this command.
If you want to disable the function for a specific interface on the device, use the
command.
You can display the status of this function and other information with the
info
390
command.
command.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
gmrp
show vlan device
no gvrp
show vlan device