10.5.3
Commands in the QOS configuration mode
This section describes commands that you can call up in the QOS configuration mode.
In the Global configuration mode, enter the
● If you exit the QOS configuration mode with the
configuration mode.
● If you exit the QOS configuration mode with the
Privileged EXEC mode.
10.5.3.1
cos-map
Description
In a network, each data stream is assigned a service class that decides its priority. In special
situations, it may be necessary to change this priority.
This change is made using a table in which the service classes are assigned to another
queue.
With this command, you configure the assignment table for service classes.
With queues 1 - 6 frames with a lower priority are occasionally processed even if there are
frames with high priority in the queue.
With queues 7 - 8 only frames with a high priority are processed as long as there are frames
with high priority in the queue.
Requirement
You are in the QOS configuration mode.
The command prompt is as follows:
cli(config-qos)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
command to change to this mode.
qos
command, you return to the Global
exit
command, you return to the
end
Load control
10.5 Service classes
671