Zone Table Settings - YASKAWA SGD7S-1R9D Product Manual

ZONE Table Settings and ZONE Numbers
The relationship between the ZONE table settings and the ZONE numbers is shown below.
• ZONE N ≤ ZONE P
The ZONE signals for the corresponding ZONE number is output if the current value is
between ZONE N and ZONE P, inclusive (the shaded part in the following figure).
• ZONE P < ZONE N
The ZONE signals for the corresponding ZONE number is output if the current value is less
than or equal to ZONE P or greater than or equal to ZONE N (the shaded parts in the follow-
ing figure).
• Duplicated Settings in the ZONE Table
The smaller ZONE number is output.
• ZONE N and ZONE P = 0
The ZONE number is disabled.
• When the Current Value Is Not In Any ZONE
All of the ZONE signals will be OFF (0).
6.14.2

ZONE Table Settings

The ZONE table is set by setting the ZONE table positive side boundary position (ZONE P)
(2750 hex) and the ZONE table negative side boundary position (ZONE N) (2751 hex).
Index
2750 hex
ZONE N
ZONE P
Subindex Name
ZONE table Positive side boundary position (ZONE P)
1 ZONE ID 0
2 ZONE ID 1
3 ZONE ID 2
4 ZONE ID 3
5 ZONE ID 4
6 ZONE ID 5
7 ZONE ID 6
8 ZONE ID 7
9 ZONE ID 8
10 ZONE ID 9
11 ZONE ID 10
12 ZONE ID 11
13 ZONE ID 12
14 ZONE ID 13
15 ZONE ID 14
16 ZONE ID 15
6.14 ZONE Outputs (FT64 Specification)
ZONE P
ZONE N
Access PDO Mapping
RW No Pos.unit
RW No Pos.unit
RW No Pos.unit
RW No Pos.unit
RW No Pos.unit
RW No Pos.unit
RW No Pos.unit
RW No Pos.unit
RW No Pos.unit
RW No Pos.unit
RW No Pos.unit
RW No Pos.unit
RW No Pos.unit
RW No Pos.unit
RW No Pos.unit
RW No Pos.unit
6.14.2 ZONE Table Settings
Parameter
Unit Data Type
No.
DINT PnA00
DINT PnA04
DINT PnA08
DINT PnA0C
DINT PnA10
DINT PnA14
DINT PnA18
DINT PnA1C
DINT PnA20
DINT PnA24
DINT PnA28
DINT PnA2C
DINT PnA30
DINT PnA34
DINT PnA38
DINT PnA3C
Continued on next page.
6
6-59