YASKAWA SGD7S-1R9D Product Manual page 565

16.1 List of Parameters
16.1.2 List of Parameters
Parameter
No.
Pn510
(2510 hex)
Pn511
(2511 hex)
16-24
Name
Output Signal Selec-
2
tions 3
/NEAR (Near Output) Signal Allocation
0 Disabled (the above signal output is not used).
1 Output the signal from the CN1-1 or CN1-2 output terminal.
2 Output the signal from the CN1-23 or CN1-24 output terminal.

n. X
3 Output the signal from the CN1-25 or CN1-26 output terminal.
4 Output the signal from the CN1-27 or CN1-28 output terminal.
5 Output the signal from the CN1-29 or CN1-30 output terminal.
6 Reserved setting (Do not use.)
 
n. X Reserved parameter (Do not change.)
 
n. X Reserved parameter (Do not change.)

n.X Reserved parameter (Do not change.)
Input Signal Selections
2
5

n. X Reserved parameter (Do not change.)
/Probe1 (Probe 1 Latch Input) Signal Allocation
4 Active when CN1-10 input signal is ON (closed).
5 Active when CN1-11 input signal is ON (closed).
6 Active when CN1-12 input signal is ON (closed).
 
n. X 7 The signal is always inactive.
8 The signal is always inactive.
D Active when CN1-10 input signal is OFF (open).
E Active when CN1-11 input signal is OFF (open).
F Active when CN1-12 input signal is OFF (open).
/Probe2 (Probe 2 Latch Input) Signal Allocation
 
n. X
The allocations are the same as the /Probe1 (Probe 1 Latch Input) signal allo-
0 to F
cations.
/Home (Home Switch Input) Signal Allocation

n.X
The allocations are the same as the /Probe1 (Probe 1 Latch Input) signal allo-
0 to F
cations.
Setting Setting Default
Range Unit Setting
0000 hex to 0000
–
0666 hex hex
0000 hex to 6543
–
FFFF hex hex
Continued from previous page.
Applicable When Classi-
Motors Enabled fication
After
All Setup
restart
Reference
page 6-11
After
All Setup
restart
Continued on next page.
Refer-
ence
–
page
6-4