Resetting Alarms - YASKAWA SGD7S-1R9D Product Manual

15.2.3

Resetting Alarms

If there is an ALM (Servo Alarm) signal, use one of the following methods to reset the alarm
after eliminating the cause of the alarm.
Be sure to eliminate the cause of an alarm before you reset the alarm.
If you reset the alarm and continue operation without eliminating the cause of the alarm, it may
result in damage to the equipment or fire.
Important
Clearing Alarms and Warnings with the Fault Reset Com-
mand
Execute the Fault Reset command to clear alarms or warnings.
Refer to the following section for details on the Fault Reset command.

Controlword Bits on page 14-21
Resetting Alarms Using the Digital Operator
Press the ALARM RESET Key on the Digital Operator. Refer to the following manual for details
on resetting alarms.
Σ-7-Series Digital Operator Operating Manual (Manual No.: SIEP S800001 33)
15.2 Alarm Displays

15.2.3 Resetting Alarms

15-39
15