YASKAWA SGD7S-1R9D Product Manual page 551

16.1 List of Parameters
16.1.2 List of Parameters
Parameter
No.
Pn022
(2022 hex)
Pn023
(2023 hex)
Pn040
(2040 hex)
Pn080
(2080 hex)
16-10
Name
Application Function
2
Selections 22
Overtravel Release Method Selection
0 Overtravel exists while the P-OT or N-OT signal is being input.

n. X
Overtravel exists while the P-OT or N-OT signal is input and the
1 current position of the workpiece is separated from the P-OT sig-
nal or N-OT signal.
 
n. X Reserved parameter (Do not change.)
 
n. X Reserved parameter (Do not change.)

n.X Reserved parameter (Do not change.)
Application Function
2
Selections 23
n.  X
Built-in Brake Relay Usage Selection
0 Use the built-in brake relay.
1 Do not use the built-in brake relay.
n.  X 
Reserved parameter (Do not change.)
n.  X 
Reserved parameter (Do not change.)
n.X 
Reserved parameter (Do not change.)
Reserved parameter (Do
2
not change.)
Application Function
2
Selections 80
Polarity Sensor Selection

n. X 0 Use polarity sensor.
1 Do not use polarity sensor.
Motor Phase Sequence Selection
 
n. X 0 Set a phase-A lead as a phase sequence of U, V, and W.
1 Set a phase-B lead as a phase sequence of U, V, and W.
 
n. X Reserved parameter (Do not change.)
Calculation Method for Maximum Speed or Encoder Output Pulses
Calculate the encoder output pulse setting for a fixed maximum
0

n.X speed.
Calculate the maximum speed for a fixed encoder output pulse
1
setting.
Setting Setting Default
Range Unit Setting
0000 hex to 0000
–
0011 hex hex
0000 hex to 0000
–
0001 hex hex
0000 hex to 0000
–
2111 hex hex
0000 hex to 0000
–
1111 hex hex
Continued from previous page.
Applicable When Classi-
Motors Enabled fication
After
All Setup
restart
Reference
page 5-30
After
All Setup
restart
Reference
page 5-30
– – –
After
Linear Setup
restart
Reference
page 5-22
Reference
page 5-20
Reference
page 17-6
Continued on next page.
Refer-
ence
–
–
–
–