YASKAWA SGD7S-1R9D Product Manual page 113

4.7 Connecting Dynamic Brake Resistors
4.7.2 Connecting a Dynamic Brake Resistor
3.
Remove the sheath from the wire to connect.
4.
Open the wire insertion hole on the terminal connector with the screwdriver.
5.
Insert the conductor of the wire into the wire insertion hole.
After you insert the conductor, remove the screwdriver.
6.
Connect the Dynamic Brake Resistor to the D1 and D2 terminals on the SERVOPACK.
Note: 1. The D1 and D2 are in the locations shown in the following figure. Do not connect anything to the
7.
Set Pn601 (Dynamic Brake Resistor Allowable Energy Consumption) and Pn604
(Dynamic Brake Resistance).
Refer to the following section for details on the settings.
4-38
7 mm
Wire
D3 terminal.
2. Terminal labels (D1 and D2) are provided on the Dynamic Brake Resistor connector.
5.18 Setting the Energy Consumption and Resistance of the Dynamic Brake Resistor on page 5-56