Encoder Divided Pulse Output; Encoder Divided Pulse Output Signals - YASKAWA SGD7S-1R9D Product Manual

6.5 Encoder Divided Pulse Output

6.5.1 Encoder Divided Pulse Output Signals

6.5

Encoder Divided Pulse Output

The encoder divided pulse output is a signal that is output from the encoder and processed
inside the SERVOPACK. It is then output externally in the form of two phase pulse signals
(phases A and B) with a 90° phase differential. At the host controller, it is used as the position
feedback.
The following table describes the signals and output phase forms.
6.5.1

Encoder Divided Pulse Output Signals

Type
Output
*
Refer to the following section for information on the origin within one encoder rotation.

SERVOPACK When Using a RGS20 Scale and RGH22B Sensor Head on page 6-19
• Rotary Servomotor
ENC
• Linear Servomotors
Linear
encoder
ENC
6-18
Signal Connector Pin No.
PAO CN1-17
/PAO CN1-18
PBO CN1-19
/PBO CN1-20
PCO CN1-21
/PCO CN1-22
Relation between Renishaw PLC Incremental Linear Encoders and Encoder Output Pulse Signal from the
CN2
Serial
Conversion of
data
serial data to
pulses
CN2
Serial data
Serial
Converter Unit
Name
Encoder Divided Pulse Output,
Phase A
Encoder Divided Pulse Output,
Phase B
Encoder Divided Pulse Output,
Phase C*
SERVOPACK
CN1
Dividing
circuit
(Pn212)
SERVOPACK
Conversion of
Dividing
serial data to
circuit
pulses
(Pn281)
Remarks
• Rotary Servomotors
These encoder divided pulse
output pins output the number
of pulses per motor resolution
that is set in Pn212 (Number of
Encoder Output Pulses). The
phase difference between
phase A and phase B is an
electric angle of 90°.
• Linear Servomotors
These encoder divided pulse
output pins output pulses at the
resolution that is set in Pn281
(Encoder Output Resolution).
The phase difference between
phase A and phase B is an
electric angle of 90°.
These pins output one pulse
every motor rotation.
Host controller
PAO
PBO
PCO
Host controller
CN1
PAO
PBO
PCO