Figure 383. Enhanced Receive Descriptor Field Format With Ieee1588 Time Stamp Enabled - STMicroelectronics STM32F405 Reference Manual

RM0090
Figure 383. Enhanced receive descriptor field format with IEEE1588 time stamp
RDES 0
RDES 1
RDES 2
RDES 3
RDES 4
RDES 5
RDES 6
RDES 7
•
RDES4: Receive descriptor Word4
The extended status, shown below, is valid only when there is status related to IPv4
checksum or time stamp available as indicated by bit 0 in RDES0.
31 30 29 28 27 26 25
Bits 31:14 Reserved, must be kept at reset value.
Bit 13 PV: PTP version
When set, indicates that the received PTP message uses the IEEE 1588 version 2 format.
When cleared, it uses version 1 format. This is valid only if the message type is non-zero.
Bit 12 PFT: PTP frame type
When set, this bit indicates that the PTP message is sent directly over Ethernet. When this bit
is cleared and the message type is non-zero, it indicates that the PTP message is sent over
UDP-IPv4 or UDP-IPv6. The information on IPv4 or IPv6 can be obtained from bits 6 and 7.
Ethernet (ETH): media access control (MAC) with DMA controller
31
O
W
N
CT Reserved Buffer 2 byte count
RL [30:29]
Buffer 2 address [31:0] or Next descriptor address [31:0]
24 23 22 21 20 19 18 17 16 15 14 13 12 11 10
Reserved
DocID018909 Rev 11
enabled
Status [30:0]
CTRL
[28:16] [15:14]
Buffer 1 address [31:0]
Extended Status [31:0]
Reserved
Time stamp low [31:0]
Time stamp high [31:0]
PV
rw rw rw rw rw rw rw rw rw rw rw rw rw rw
Buffer 1 byte count
Res.
[12:0]
9 8 7 6 5 4
PMT
0
ai17104
3 2 1 0
IPPT
1179/1731
1232