Rtc Alarm A Register (Rtc_Alrmar) - STMicroelectronics STM32F405 Reference Manual

RM0090
Note: This register can be written in initialization mode only (RTC_ISR/INITF = '1').
This register is write protected. The write access procedure is described in
write protection on page
26.6.8

RTC alarm A register (RTC_ALRMAR)

Address offset: 0x1C
Backup domain reset value: 0x0000 0000
System reset: not affected
31 30 29
MSK4 WDSEL DT[1:0]
rw rw rw
15 14 13
MSK2 MNT[2:0]
rw rw rw
Bit 31 MSK4: Alarm A date mask
0: Alarm A set if the date/day match
1: Date/day don't care in Alarm A comparison
Bit 30 WDSEL: Week day selection
0: DU[3:0] represents the date units
1: DU[3:0] represents the week day. DT[1:0] is don't care.
Bits 29:28 DT[1:0]: Date tens in BCD format.
Bits 27:24 DU[3:0]: Date units or day in BCD format.
Bit 23 MSK3: Alarm A hours mask
0: Alarm A set if the hours match
1: Hours don't care in Alarm A comparison
Bit 22 PM: AM/PM notation
0: AM or 24-hour format
1: PM
Bits 21:20 HT[1:0]: Hour tens in BCD format.
Bits 19:16 HU[3:0]: Hour units in BCD format.
Bit 15 MSK2: Alarm A minutes mask
0: Alarm A set if the minutes match
1: Minutes don't care in Alarm A comparison
Bits 14:12 MNT[2:0]: Minute tens in BCD format.
Bits 11:8 MNU[3:0]: Minute units in BCD format.
Bit 7 MSK1: Alarm A seconds mask
0: Alarm A set if the seconds match
1: Seconds don't care in Alarm A comparison
Bits 6:4 ST[2:0]: Second tens in BCD format.
Bits 3:0 SU[3:0]: Second units in BCD format.
794.
28 27 26 25
DU[3:0]
rw rw rw rw
12 11 10 9
MNU[3:0]
rw rw rw rw
DocID018909 Rev 11
24 23 22 21
MSK3 PM HT[1:0]
rw rw rw rw
8 7 6 5
MSK1 ST[2:0]
rw rw rw rw
Real-time clock (RTC)
RTC register
20 19 18 17
HU[3:0]
rw rw rw rw
4 3 2 1
SU[3:0]
rw rw rw rw
16
rw
0
rw
815/1731
828