Policy Condition Ipv6 - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

Hide thumbs Also See for OmniSwitch 6250:

Table of Contents

QoS Policy Commands

policy condition ipv6

Configures a policy condition to classify IPv6 traffic.

policy condition condition_name ipv6

policy condition condition_name no ipv6

Syntax Definitions

condition_name

Platforms Supported

OmniSwitch 6250

Usage Guidelines

Use the no form of the command to remove IPv6 traffic as a condition; however, at least one classifi-

cation parameter must be associated with a condition.

When the ipv6 keyword is used in a condition, a policy that uses the condition is considered an IPv6

policy. IPv6 policies are effected only on IPv6 traffic. All other IP policies are considered IPv4 poli-

cies and are effected only on IPv4 traffic.

IPv6 Layer 4 policies are supported and are configured using the ipv6 keyword in a condition that

specifies Layer 4 information, services, or service groups. Note that IPv6 Layer 4 policies only work

with packets that contain a single header.

The icmptype and icmpcode keywords in an IPv6 policy imply the ICMPv6 protocol, not the ICMPv4

-> policy condition cond4 ipv6

-> policy condition cond5 ipv6 tos 7

-> policy condition cond6 ipv6 source port 1/1

-> policy condition cond7 ipv6 source tcp port 21

-> policy condition cond8 ipv6 source tcp port 0-1024

-> policy condition cond6 no ipv6

Release History

Release 6.6.1; command was introduced.

OmniSwitch CLI Reference Guide

The name of the condition.

November 2009