Policy Condition Destination Mac - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

Hide thumbs Also See for OmniSwitch 6250:

Table of Contents

QoS Policy Commands

policy condition destination mac

Configures a destination MAC address for a policy condition.

Note. Specifying a destination MAC address and mask of all zeros (00:00:00:00:00:00) as a policy condi-

tion can result in the switch dropping all traffic. Only use this type of condition in combination with other

policies that will allow desired traffic and/or if a source or destination slot/port is also part of the destina-

tion MAC condition.

policy condition condition_name destination mac mac_address [mask mac_mask]

policy condition condition_name no destination mac

Syntax Definitions

condition_name

Platforms Supported

OmniSwitch 6250

Usage Guidelines

Use the no form of the command to remove a destination MAC address from a condition; however, at

least one classification parameter must be associated with a condition.

A destination MAC address and a destination MAC group cannot be specified in the same condition.

-> policy condition cond3 destination mac 00:20:da:05:f6:23

Release History

Release 6.6.1; command was introduced.

OmniSwitch CLI Reference Guide

The name of the condition. May be an existing condition name or a new

The destination MAC address in the Layer 2 header of the frame (for

example, 00:20:da:05:f6:23).

Optional. The mask for the destination MAC address (for example,

ff:ff:ff:ff:ff:ff).

November 2009