Policy Action Dscp - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

policy action dscp

Configures a Differentiated Services Code Point (DSCP) value to be set in an outgoing flow for traffic that
matches rules with this action.
policy action action_name dscp dscp_value
policy action action_name no dscp
Syntax Definitions
action_name
dscp_value
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the no form of this command to remove a DSCP value from a policy action.
•
Note that specifying both ToS and DSCP in the same action is not allowed.
•
An 802.1p or ToS/DSCP action always sets the packet priority. For 802.1p marking, the priority is set
according to the marked 802.1p. For ToS marking, the priority is set according to the marked ToS. For
DSCP marking, the priority is set according to the marked DSCP.
Examples
-> policy action action2 dscp 61
-> policy action action2 no dscp
Release History
Release 6.6.1; command was introduced.
Related Commands
qos apply
policy action
show policy action
page 39-126
The name of the action.
The DSCP value to be set, in the range 0–63.
Applies configured QoS and policy settings to the current configuration.
Creates a policy action.
Displays information about actions configured on the switch.
OmniSwitch CLI Reference Guide
QoS Policy Commands
November 2009