policy condition multicast network group
Associates a multicast group with a policy condition.
policy condition condition_name multicast network group multicast_group
policy condition condition_name no multicast network group
Syntax Definitions
condition_name
multicast_group
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the no form of the command to remove a multicast group from a condition; however, at least one
classification parameter must be associated with a condition.
•
A multicast address and a multicast network group cannot be specified in the same condition.
Examples
-> policy condition cond3 multicast group video2
Release History
Release 6.6.1; command was introduced.
Related Commands
qos apply
policy condition
policy network group
show policy condition
show policy network group
page 39-52
The name of the condition.
The multicast group name. Multicast groups are configured through the
policy network group command.
Applies configured QoS and policy settings to the current configuration.
Creates a policy condition.
Configures a network group name and its associated IP addresses.
Shows information about policy conditions configured on the switch.
Displays information about policy network groups.
OmniSwitch CLI Reference Guide
QoS Policy Commands
November 2009