Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual page 1567

QoS Policy Commands
•
Note that even though tcpflags can be used with most action parameters, it is mainly intended for ACL
use.
Examples
-> policy condition c1 tcpflags all f s mask f s a
-> policy condition c2 tcpflags any a r mask a r
Release History
Release 6.6.1; command was introduced.
Related Commands
qos apply
policy condition
show policy condition
MIB Objects
alaQoSConditionTable
alaQoSConditionTcpFlags,
alaQoSConditionTcpFlagsStatus,
alaQoSConditionTcpFlagsVal,
alaQoSConditionTcpFlagsValStatus,
alaQoSConditionTcpFlagsMask,
alaQoSConditionTcpFlagsMaskStatus,
alaQoSAppliedConditionTable
alaQoSAppliedConditionTcpFlags,
alaQoSAppliedConditionTcpFlagsStatus,
alaQoSAppliedConditionTcpFlagsVal,
alaQoSAppliedConditionTcpFlagsValStatus,
alaQoSAppliedConditionTcpFlagsMask,
alaQoSAppliedConditionTcpFlagsMaskStatus,
OmniSwitch CLI Reference Guide
Applies configured QoS and policy settings to the current configuration.
Creates a policy condition.
Shows information about policy conditions configured on the switch.
November 2009 page 39-71