Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual page 1606

Usage Guidelines
•
Any condition parameters that the hardware supports will be used to classify the traffic; any condition
parameters that are not supported by the hardware will not be used to classify traffic, and the event will
be logged in the QoS log.
•
Bandwidth and queue parameters may be specified when the action is created or may be specified as
separate commands.
•
Use the qos apply
•
Use the no form of the command to remove a QoS action from the configuration.
•
If the snapshot command is entered after the policy action command is configured, the resulting
ASCII file will include the following additional syntax for the policy action command:
from {cli | ldap | blt}
This syntax indicates how the action was created. The cli and ldap options may be changed by a user
modifying the ASCII file; however, changing this setting is not recommended. The blt option indicates
a built-in action, this setting is not configurable.
Examples
-> policy action action1 accept
Release History
Release 6.6.1; command was introduced.
Related Commands
policy condition
qos apply
show policy action
MIB Objects
alaQoSActionTable
alaQoSActionName
alaQoSActionSource
alaQoSActionDisposition
alaQoSActionMinimumBandwidth
alaQoSActionMaximumBandwidth
alaQoSActionPeakBandwidth
alaQoSActionPriority
alaQoSActionShared
alaQoSActionMaximumBuffers
alaQoSActionMaximumDepth
alaQoSAction8021p
alaQoSActionTos
alaQoSActionTosRewriteMask
alaQoSActionDscp
alaQoSActionMapFrom
alaQoSActionMapTo
alaQoSActionMapGroup
page 39-110
command to activate configuration changes.
Configures a condition associated with the action.
Applies configured QoS and policy settings to the current configuration.
Displays information about policy actions.
OmniSwitch CLI Reference Guide
QoS Policy Commands
November 2009