Table of Contents
Advertisement
This chapter describes the Internet Protocol (IP) configuration set of commands and how to use
them.
For information about...
Configuring Routing Interface Settings
Reviewing and Configuring the ARP Table
Configuring Broadcast Settings
Reviewing IP Traffic and Configuring Routes
Configuring Routing Interface Settings
Purpose
To enable routing interface configuration mode on the device, to create routing interfaces, to
review the usability status of interfaces configured for IP, to set IP addresses for interfaces, to
enable interfaces for IP routing at device startup, and to review the running configuration.
Commands
For information about...
show interface
interface
show ip interface
ip address
show running-config
no shutdown
no ip routing
Router: Unless otherwise noted, the commands covered in this chapter can be executed only
when the device is in router mode. For details on how to enable router configuration modes, refer
to
"Enabling Router Configuration
IP Configuration
Modes" on page 16-2.
SecureStack B3 Configuration Guide 17-1
17
Refer to page...
17-1
17-7
17-11
17-13
Refer to page...
17-2
17-2
17-3
17-4
17-5
17-6
17-6
Advertisement
Table of Contents
