Configuring System Identification - Avaya 5900 Series Quick Start Configuration

***
*** HW:R0D.7
***************************************************************
Variable definitions
Use the definitions in the following table to use the banner command.
Variable
custom
static
<line_number>
<LINE>

Configuring system identification

About this task
You can configure system identification to specify the system name, contact person, and location of
the switch, and to add a trap receiver to the trap-receiver table.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. Enable the Simple Network Management Protocol (SNMP) server:
snmp-server enable
3. Configure the read-only community name:
snmp-server community ro
Note:
Enter the community string twice.
If you ran the install script to set up the configuration information, the read-only
community name is already configured.
4. Configure the read-write community name:
snmp-server community rw
October 2015
FW:0.0.0.2c SW:v7.0.0.056
Quick Start Configuration for Avaya ERS 5900 Series
Comments on this document? infodev@avaya.com
Configuring system identification
***
***
Definition
Disable the use of the default banner.
Activate the use of the default banner.
Banner line number you are configuring. The range
is 1 to 19
Specify the characters in the line number.
33