Verifying The Snmp Access Configuration Status; Viewing The Snmp Trap Receiver Configuration; Adding An Snmpv1 Trap Receiver - Avaya Virtual Services Platform 7000 Series Troubleshooting Manual

Troubleshooting RSTP SNMP traps
enable
configure terminal
2. Use the show snmp-server notification-control command to display the status of
SNMP traps.
3. Observe the command output display for the status of RSTP-related traps.

Verifying the SNMP access configuration status

Use this procedure to verify that SNMP access is enabled on the IP manager list.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. Use the show ipmgr command to display the IP manager configuration.
3. Observe the command output display to determine if SNMP access is enabled or disabled.
4. If required, use the snmp-server enable command to enable SNMP access.
5. You can repeat steps 2 and 3 to confirm the configuration change.

Viewing the SNMP trap receiver configuration

Use this procedure to view and analyze the SNMP trap receiver configuration.
Procedure
1. Enter Privileged EXEC mode:
enable
2. Use the show snmp-server host command to display the trap receiver configuration.
3. Observe and analyze the command output display.

Adding an SNMPv1 trap receiver

Use this procedure to add an SNMPv1 trap receiver to the trap receiver table.
Troubleshooting Avaya VSP 7000 Series
62
Comments on this document? infodev@avaya.com
July 2015