Clear Radius Authentication Server; Clear Snmp Trap - Avaya P460 Reference Manual

Chapter 2 Avaya P460 CLI Commands
The syntax for this command is:
clear port static-vlan [module/port range][vlan num]
module/port range
vlan num
Example:
P460-1# clear port static-vlan 3/10 5
VLAN 5 is unbound from port 3/10

clear radius authentication server

User level: read-write, admin.
Removes a primary or secondary RADIUS authentication server.
The syntax for this command is:
clear radius authentication server[{primary|secondary}]
primary
secondary
Example:
P460-1(super)# clear radius authentication server secondary

clear snmp trap

User level: read-write, admin.
Use the clear snmp trap command to clear an entry from the SNMP trap
receiver table.
The syntax for this command is:
clear snmp trap {<rcvr_addr>|all}
rcvr_addr
all
20
Port range
The VLAN to unbind from the port
Remove primary RADIUS server
Remove secondary RADIUS server
IP address or IP alias of the trap receiver (the SNMP management
station) to clear
Keyword that specifies every entry in the SNMP trap receiver
table
Avaya P460 Reference Guide