Table of Contents
Advertisement
no snmp-server host
User level: supervisor
Use the no snmp-server host command to either delete the host from the trap
recipients list or, if notifications types are specified in the command, disable the
specified notifications for the host.
The syntax for this command is:
no snmp-server host <host-addr> [<notification-type-list>]
host-addr
notification
-type-list
(Optional)
Avaya P330-ML Reference Guide
Chapter 2
Specifies the address (or host name) of the notification recipient
agent. The maximum length is 32 bytes.
List of notification types. Each types combines related
notifications. You can disable notification generations on a per
group basis. For example, the swRedundancy type groups new
and delete software redundancy notifications.
If no notification-type-list is specified, the default, all, is used.
• all/* – All traps
• generic – Generic traps
• config – Config change notifications
• eth-port-faults – Ethernet port fault notifications
• sw-redundancy – Software redundancy notifications
• temperature – Temperature warning notifications
• cam-change – Changes in CAM notifications
• l3-faults – Layer 3 faults, including duplicate IP and
VLAN violations
• lag-event – Link aggregation faults and configuration
changes
• policy – Changes in policy notifications (for L3 devices)
• link-down-faults – ITC proprietary link down
notifications
• supply – Power supply notifications (main and backup)
• fan – FAN faults notifications (main and backup)
• cascade – Cascade connection fault notifications.
Note that the list of notification names is proprietary to ITC.
Avaya P330-ML Layer 2 CLI Commands
49
Advertisement
Table of Contents
