Configuring The Remote Host Logon - Avaya 8800 Commissioning Manual

Remote connection configuration using the CLI

Configuring the remote host logon

Configure the remote host logon to modify parameters for FTP and TFTP access. Use the
default parameters for TFTP transfers. If you want to use FTP as the transfer mechanism, you
need to change the password to a valid value.
Procedure steps
1. Define conditions for the remote host logon by using the following command:
2. Save the changed configuration to the boot.cfg and pcmboot.cfg files.
3. Restart the switch.
Variable definitions
Use the data in the following table to use the config bootconfig host command.
Variable
ftp-debug <true|false>
info
password <value>
tftp-debug <true|false>
tftp-hash <true|false>
tftp-rexmit <seconds>
90 Commissioning
config bootconfig host
Enables or disables debug mode on FTP. If you enable debug
mode, debug messages appear on the management console
screen. The default is false.
Displays the current remote host logon settings.
Configures the password to enable FTP transfers. value is the
password, up to 16 characters long. After you configure this
password, use only FTP for remote host logon.
Important:
This password must match the password for the FTP server,
or the FTP operation fails. Also, if you configure the password
to a valid value, then all copying to and from the network uses
FTP instead of TFTP. If the user name or password is
incorrect, copying over the network fails.
Enables or disables debug mode on TFTP/TFTPD. If you
enable debug mode, debug messages appear on the
management console screen. The default is false.
Enables or disables the TFTP hash bucket display. The default
is false.
Configures the TFTP retransmission timeout. The default value
is 2 seconds. seconds is the number of seconds (1–
2147483647).
Value
June 2011