Configuring An In-Band Management Ipv6 Address - Avaya 5900 Series Quick Start Configuration

Configuring management IP addresses using ACLI
Variable
<destination-IP>
<destination-netmask>
<destination-gateway>

Configuring an in-band management IPv6 address

Use this procedure to configure the in-band management IPv6 address for a switch or stack.
Important:
Changing or clearing the in-band management IPv6 address disconnects any active IP
management connections.
About this task
You can dynamically change the in-band management IPv6 address using Telnet, SSH, SNMP,
HTTP, and HTTPS.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. To assign or modify the in-band management IPv6 address for a switch or stack, enter the
following at the command prompt:
ipv6 address [switch | stack | unit <1–8>] <WORD>
Note:
You configure the stack in-band management IPv6 address on the stack base unit.
Important:
Only one management default gateway can operate for each unit or stack. The out-of-
band management default gateway takes precedence over the in-band management
default gateway. Once an out-of-band management default gateway is configured, the
in-band management address is reachable only through a directly attached subnet for
the management VLAN.
3. To assign the default gateway, enter the following at the command prompt:
ipv6 default-gateway <WORD>
4. To clear the in-band management IPv6 address and the default gateway, enter the following
commands at the command prompt:
no ipv6 address [switch | stack | unit <1–8>]
October 2015
Value
Specifies the destination IPv4 address.
Specifies the destination IPv4 subnet mask.
Specifies the destination IPv4 gateway.
Quick Start Configuration for Avaya ERS 5900 Series
Comments on this document? infodev@avaya.com
62