Basic Configuration - Avaya P333T-PWR Quick Start Manual

Basic configuration

To connect a PC terminal or VT-100 terminal to the Avaya P330
1. If you are using a PC, initiate a VT-100 terminal emulation session using an application
such as Windows® HyperTerminal.
2. Press Enter.
The Welcome to Cajun P330 menu is displayed.
3. Type the User name root when prompted and press Enter.
4. Type the default password root when prompted and press Enter.
The Cajun_P330-N(super)# prompt appears
N is the number of the switch in the stack.
Assigning the Stack IP Address
Commands are shown as follows: set interface inband;
parameters which you need to enter are shown in <> as follows: <vlan>
1. Type set interface inband <vlan> <ip_address> <netmask> replacing
<vlan>, <ip_address> and <netmask> with the VLAN, IP address and net mask of
the stack and press Enter.
2. Type reset and press Enter to reset the stack.
3. After the Reset, perform login again as described above.
The Cajun_P330-N(super)# prompt appears.
4. Type set ip route <destination> <gateway> , replacing <destination> and
<gateway> with the destination and gateway IP addresses.
5. Press Enter to save the destination and gateway IP addresses.
5