Chapter 6: Common Procedures; Abandoning A Command - Avaya 5000 Series Installing

Chapter 6: Common procedures

About this task
This module contains procedures that are common to more than one product line.

Abandoning a command

About this task
This procedure describes how to abandon a command entered using the UI/Mode Select
button.
Note:
The UI button is labeled Mode Select on Avaya branded equipment.
Abandoning a command entered using the UI/Mode Select button
Procedure
1. Do not confirm a command within approximately twenty seconds after you enter the
2. Press the UI/Mode Select button nine or more times to exit configuration mode.
Installing Avaya Ethernet Routing Switch 5000 Series
command and the system ignores the input.
Note:
Wait sixty seconds after the last configuration change before resetting the unit.
The system can take up to this long to save configuration changes to the NVRAM.
Stacks can be reset immediately after the last configuration change without any
loss of information.
December 2013 73