Table of Contents
Advertisement
Low Coast Brake Fluid Pressure Switch Input Signal
Low Coast Brake Solenoid Input Signal
NOTE:
For details concerning operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MAN-
UAL.
3. CLEAR MEMORY MODE
NOTE:
To clear the previous DTC, use {Clear Memory},
and to clear the learned value, use {Clear Memory
2}.
1) Check that the select lever is in "P" range.
2) On the «Main Menu» display screen, select the
{Each System Check} and press the [YES] key.
3) On the «System Selection Menu» display
screen, select the {Transmission} and press the
[YES] key.
4) Press the [YES] key after the information of
transmission type is displayed.
5) On the «Transmission Diagnosis» display
screen, select the {Clear Memory} and press the
[YES] key.
NOTE:
If {Clear Memory 2} is selected and performed,
DTC may not be cleared.
6) When the "Done" are shown on the display
screen, turn off the Subaru Select Monitor and turn
the ignition switch to OFF. To turn the ignition
switch ON again, wait for more than 10 seconds.
NOTE:
For details concerning operation procedure, refer
to the SUBARU SELECT MONITOR OPERATION
MANUAL.
Subaru Select Monitor
Item
5AT(diag)-19
AUTOMATIC TRANSMISSION (DIAGNOSTICS)
Display
LC/B Fluid Pressure
LC/B Solenoid
Unit of measure
ON or OFF
ON or OFF
Advertisement
Chapters
Table of Contents
