Subaru Legacy 2005 Service Manual page 2828

CLUTCH SYSTEM
2. RHD MODEL
1) Remove the clutch switch.
2) Remove the clip, and then pull out the clevis pin.
(A)
(A) Clevis pin
3) Remove the assist rod, spring and bushing.
4) Remove the clutch pedal from clutch pedal
bracket.
(A)
(B)
(A) Clutch pedal bracket
(B) Clutch pedal
5) Remove the following parts (B — G) from clutch
pedal bracket (A) as shown in the figure.
(B)
(G)
(F)
(A) Clutch pedal bracket
(B) Bushing C
(C) Clip (2.0 L model and 2.5 L model)
(D) Bushing S (2.0 L model and 2.5 L model)
(E) Spring S (2.0 L model and 2.5 L model)
(F) Rod S (2.0 L model and 2.5 L model)
(G) Stopper
Clutch Pedal
CL-00127
CL-00128
(A)
(C)
(D)
(E)
CL-00184
6) Remove the spacer, bushing and pedal pad from
clutch pedal.
(F)
(B)
(F)
(A) Spacer
(B) Bushing
(C) Stopper
(D) Pedal pad
(E) Clutch pedal
(F) Bushing C
D: ASSEMBLY
1. LHD MODEL
1) Attach the clutch switch, etc. to pedal bracket
temporarily.
2) Clean the inside of bores of clutch pedal and
brake pedal, apply a thin coat of grease, and then
set bushings into bores.
3) Align the bores of pedal bracket, clutch pedal
and brake pedal, and then attach the brake pedal
return spring, assist rods, spring and bushing.
NOTE:
Clean up the inside of bushings and apply a thin
coat of grease before installing spacer.
2. RHD MODEL
1) Clean the sliding surfaces of clutch pedal and
bushing, and apply a thin coat of grease on them.
2) Install the pad, stopper, bushing C, spacer and
bushing to clutch pedal.
3) Install the rod S, spring S, bushing S, clip, bush-
ing, clutch switch and bushing C to clutch pedal
bracket.
CL-38
(A)
(B)
(C)
(D)
(E)
CL-00130