Table of Contents
Advertisement
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
AUTOMATIC TRANSMISSION (DIAGNOSTICS)
Step
7
CHECK OUTPUT SIGNAL OF TCM.
1) Jack-up the vehicle and support with rigid
racks.
NOTE:
Raise all wheels off floor.
2) Start the engine.
3) Shift the select lever to "D" range and
slowly increase vehicle speed to 20 km/h (12
MPH).
NOTE:
The speed difference between front and rear
wheels may light the ABS warning light, but this
indicates no malfunction. When AT control di-
agnosis is finished, perform the ABS memory
clearance procedure of on-board diagnostics
system. <Ref. to ABS(diag)-26, Clear Memory
Mode.>
4) Measure the voltage between TCM and
chassis ground.
Connector & terminal
(B55) No. 15 (+) — Chassis ground (
8
CHECK POOR CONTACT.
Check
Is the voltage less than 1 V?
−
):
Is there poor contact in the
reverse inhibitor control circuit?
5AT(diag)-90
Yes
Even if the SPORT
Go to step 8.
indicator lights up,
the circuit has
returned to nor-
mal condition at
this time. A tempo-
rary poor contact
of connector or
harness may be
the cause. Repair
the harness or
connector in
reverse inhibitor
control circuit.
Repair the poor
Replace the TCM.
contact.
<Ref. to 5AT-61,
Transmission Con-
trol Module
(TCM).>
No
Advertisement
Chapters
Table of Contents
