Subaru Legacy 2005 Service Manual page 2113

4) Remove the transfer clutch pipe without deform-
ing the pipe.
5) Remove the dust cover from extension case.
6) Remove the oil seal from extension case.
D: ASSEMBLY
1. MP-T MODEL
1) Press-fit new oil seal using ST and press.
ST 498057300 INSTALLER
2) Press-fit the dust cover.
3) Install the transfer clutch pipe to extension case
without deforming the pipe.
(A) Extension case
(B) Transfer clutch pipe
Extension Case
4) Install the transfer clutch assembly to case.
NOTE:
• Be careful not to damage the seal ring.
• Insert the clutch assembly to bottom of bearing
shoulder completely.
AT-00124
2. VTD MODEL
1) Press-fit new oil seal using ST and press.
ST 498057300
2) Press-fit the dust cover.
3) Install the transfer clutch pipe to extension case
(A)
without deforming the pipe.
(B)
AT-00120
4) Apply ATF to new O-ring, and install the test
plug.
Tightening torque:
4AT-85
AUTOMATIC TRANSMISSION
(A)
(B)
(A) Transfer clutch
(B) Extension case
INSTALLER
⋅
13 N m (1.3 kgf-m, 9.6 ft-lb)
(A) Test plug
(B) Extension case
AT-00125
AT-00124
(A)
(B)
AT-00122