Subaru Legacy 2005 Service Manual page 2602

MANUAL TRANSMISSION AND DIFFERENTIAL
7. Switches and Harness
A: REMOVAL
1. BACK-UP LIGHT SWITCH AND NEU-
TRAL POSITION SWITCH
1) Disconnect the ground cable from battery.
2) Remove the air intake chamber and cleaner
case. <Ref. to IN(H4SO 2.0)-5, REMOVAL, Air
Cleaner Case.> <Ref. to IN(H4SO 2.0)-7, REMOV-
AL, Air Intake Chamber.>
3) Disconnect the connectors of back-up light
switch and neutral position switch.
(B)
(A) Neutral position switch connector (Brown)
(B) Back-up light switch connector (Gray)
4) Lift-up the vehicle.
5) Remove the back-up light switch and neutral po-
sition switch with harness.
(B)
(A) Neutral position switch (Brown)
(B) Back-up light switch (Gray)
2. HIGH-LOW SWITCH (DUAL-RANGE
MODEL)
1) Disconnect the ground cable from battery.
2) Remove the air intake chamber and cleaner
case. <Ref. to IN(H4SO 2.0)-5, REMOVAL, Air
Cleaner Case.> <Ref. to IN(H4SO 2.0)-7, REMOV-
AL, Air Intake Chamber.>
Switches and Harness
(A)
MT-00104
(A)
MT-00106
5MT-40
3) Disconnect the connector of high-low switch.
(A)
(B)
(C)
(A) Neutral position switch (Brown)
(B) Back-up light switch (Gray)
(C) High-low switch (Black)
4) Remove the high-low switch cable from clamp.
5) Remove the high-low switch.
(B)
(A) Clamp
(B) High-low switch
B: INSTALLATION
1. BACK-UP LIGHT SWITCH AND NEU-
TRAL POSITION SWITCH
1) Install the back-up light switch and neutral posi-
tion switch with harness.
Tightening torque:
⋅
25 N m (2.5 kgf-m, 18.4 ft-lb)
(B)
(A) Neutral position switch
(B) Back-up light switch
MT-00107
(A)
MT-00108
(A)
MT-00106