Subaru Legacy 2005 Service Manual page 2111

29.Extension Case
A: REMOVAL
1) Remove the transmission assembly.
<Ref. to 4AT-39, REMOVAL, Automatic Transmis-
sion Assembly.>
2) Remove the rear vehicle speed sensor.
• MP-T model
(A) Rear vehicle speed sensor
• VTD model
(A) Rear vehicle speed sensor
3) Separate the transmission case and extension
case part.
B: INSTALLATION
1) Install the selected thrust needle bearing to the
end surface of reduction drive gear with vaseline.
NOTE:
Install the thrust needle bearing in correct direction.
2) Install a new gasket.
3) Install the extension case to transmission case.
Extension Case
(A)
AT-02207
(A)
AT-00117
AT-00118
4) Tighten bolts to secure extension case.
Tightening torque:
⋅
25 N m (2.5 kgf-m, 18.4 ft-lb)
5) Install the rear vehicle speed sensor.
Tightening torque:
⋅
7 N m (0.7 kgf-m, 5.1 ft-lb)
• MP-T model
(A) Rear vehicle speed sensor
• VTD model
(A) Rear vehicle speed sensor
6) Install the transmission assembly.
<Ref. to 4AT-42, INSTALLATION, Automatic
Transmission Assembly.>
4AT-83
AUTOMATIC TRANSMISSION
AT-00118
(A)
AT-02207
(A)
AT-00117