Subaru Legacy 2005 Service Manual page 2615

2) Remove the reverse check plate, reverse check
spring, reverse check cam, return spring (5th-Rev),
reverse accent shaft, return spring cap and return
spring (1st-2nd).
(A)
(C)
(B)
(D)
(F)
(A) Reverse check plate
(B) Reverse check spring
(C) Return spring (5th-Rev)
(D) Reverse check cam
(E) Reverse accent shaft
(F) Return spring cap
(G) Return spring (1st-2nd)
3) Remove the O-ring.
NOTE:
• Visually check the O-ring. Replace if defective.
• Be careful not to break adjustment shim placed
between reverse check sleeve assembly and case.
Reverse Check Sleeve
(E)
(G)
MT-00154
5MT-53
MANUAL TRANSMISSION AND DIFFERENTIAL
D: ASSEMBLY
1) Install the return spring (1st-2nd), return spring
cap, reverse accent shaft, reverse check cam, re-
turn spring (5th-Rev.) and reverse check spring
onto reverse check sleeve.
NOTE:
Be sure to position the bent section of reverse
check spring in the groove in check cam.
(A)
(C)
(B)
(D)
(F)
(A) Reverse check plate
(B) Reverse check spring
(C) Return spring (5th-Rev)
(D) Reverse check cam
(E) Reverse accent shaft
(F) Return spring cap
(G) Return spring (1st-2nd)
2) Hook the bent section of reverse check spring
over reverse check plate.
3) Rotate the cam so that the protrusion of reverse
check cam is at the opening in plate.
4) With cam held in that position, install the reverse
check plate onto reverse check sleeve and hold
with snap ring.
5) Position the O-ring in the groove in sleeve.
(E)
(G)
MT-00154