Subaru Legacy 2005 Service Manual page 2753

21.Reverse Idler Gear
A: REMOVAL
1) Remove the manual transmission assembly
from vehicle. <Ref. to 6MT-34, REMOVAL, Manual
Transmission Assembly.>
2) Prepare the transmission for overhaul. <Ref. to
6MT-40, Preparation for Overhaul.>
3) Remove the oil pipe, neutral position switch,
back-up light switch and harness. <Ref. to 6MT-42,
REMOVAL, Oil Pipe.> <Ref. to 6MT-45, REMOV-
AL, Neutral Position Switch.> <Ref. to 6MT-43, RE-
MOVAL, Back-up Light Switch.>
4) Remove the extension case. <Ref. to 6MT-47,
REMOVAL, Extension Case.>
5) Remove the transfer driven gear. <Ref. to 6MT-
58, REMOVAL, Transfer Driven Gear.>
6) Remove the center differential. <Ref. to 6MT-60,
REMOVAL, Center Differential.>
7) Remove the oil pump. <Ref. to 6MT-61, RE-
MOVAL, Oil Pump.>
8) Remove the transmission case. <Ref. to 6MT-
64, REMOVAL, Transmission Case.>
9) Remove the reverse idler gear assembly. <Ref.
to 6MT-69, REMOVAL, Main Shaft Assembly.>
B: INSTALLATION
1) Select the reverse fork rod. <Ref. to 6MT-115,
ADJUSTMENT, Shifter Fork and Rod.>
2) Install the reverse idler gear assembly. <Ref. to
6MT-70, INSTALLATION, Main Shaft Assembly.>
3) Install the transmission case. <Ref. to 6MT-65,
INSTALLATION, Transmission Case.>
4) Install the oil pump. <Ref. to 6MT-62, INSTAL-
LATION, Oil Pump.>
5) Install the center differential. <Ref. to 6MT-60,
INSTALLATION, Center Differential.>
6) Install the transfer driven gear. <Ref. to 6MT-58,
INSTALLATION, Transfer Driven Gear.>
7) Install the extension case. <Ref. to 6MT-47, IN-
STALLATION, Extension Case.>
8) Install the oil pipe, neutral position switch, back-
up light switch and harness. <Ref. to 6MT-42, IN-
STALLATION, Oil Pipe.> <Ref. to 6MT-45, IN-
STALLATION, Neutral Position Switch.> <Ref. to
6MT-43, INSTALLATION, Back-up Light Switch.>
9) Install the manual transmission assembly into
vehicle. <Ref. to 6MT-36, INSTALLATION, Manual
Transmission Assembly.>
Reverse Idler Gear
MANUAL TRANSMISSION AND DIFFERENTIAL
C: DISASSEMBLY
NOTE:
The sleeve and reverse gear engage at a specified
position. Before disassembly, put the mark on en-
gagement position of sleeve and hub.
1) Remove the spring pin.
2) Remove the snap ring.
3) Remove the washer and reverse idler gear.
6MT-91
(A) Washer
(B) Reverse Idler Gear
MT-00617
MT-00618
(A)
(B)
MT-00619