CONTROL SYSTEMS
3. Select Lever
A: REMOVAL
1) Set the vehicle on a lift.
2) Disconnect the ground cable from battery.
3) Shift the select lever to "N" range.
4) Lift-up the vehicle.
5) Remove the rear exhaust pipe and muffler.
• SOHC model
<Ref. to EX(H4SO 2.0)-10, REMOVAL, Rear Ex-
haust Pipe.> <Ref. to EX(H4SO 2.0)-12, REMOV-
AL, Muffler.>
• DOHC non-turbo model
<Ref. to EX(H6DO)-7, REMOVAL, Rear Exhaust
Pipe.> <Ref. to EX(H6DO)-9, REMOVAL, Muffler.>
• DOHC turbo model
<Ref. to EX(H4DOTC)-11, REMOVAL, Rear Ex-
haust Pipe.> <Ref. to EX(H4DOTC)-12, REMOV-
AL, Muffler.>
6) Remove the heat shield cover.
7) Remove the select cable from arm assembly.
(A) Adjusting nut
(B) Arm ASSY
Select Lever
8) Raise the pawl of clamp to remove the select ca-
ble.
9) Lower the vehicle.
10) Remove the console box. <Ref. to EI-53, RE-
MOVAL, Console Box.>
11) Remove the ring indicator.
Insert the tip of a flap tip screwdriver into the gap
between ring indicator and console front panel, and
lift up gradually.
NOTE:
• Wrap the tip of a flat tip screwdriver with cloth.
• Insert the tip of a flat tip screwdriver into four
pawls, and remove the ring indicator equally and
gradually.
AT-01331
(B)
12) Remove the console front panel.
13) Remove the harness clips from bracket.
(A)
CS-00278
CS-22
(A) Pawl
(A)
CS-00279
CS-00583
CS-00372