Subaru Legacy 2005 Service Manual page 2739

11) Install the 5th bushing.
(1) Install to the main shaft, taking care not to
overlap the main shaft oil hole and 5th bushing
oil hole.
A
(B)
(C)
A - A
(A) 5th bushing
(B) Main shaft oil hole
(C) Main shaft
(D) 5th bushing oil hole
(E) 4th drive gear
(2) Using the ST, press into 5th bushing.
ST1 18651AA000 INSTALLER
ST2 398177700 INSTALLER
CAUTION:
Do not apply pressure in excess of 40 kN (4.0
ton, 4.4 US ton, 3.9 Imp ton).
12) Be sure 4th drive gear is rotated smoothly by
hands. If it is not rotated smoothly, reassemble it.
13) Apply sufficient amount of gear oil to the main
shaft, and the inside of 5th needle bearing and 5th
drive gear.
Main Shaft Assembly
(A)
A
(D)
(C)
(E)
(C)
(A)
(B)
MT-00566
ST1
ST2
MT-00567
6MT-77
MANUAL TRANSMISSION AND DIFFERENTIAL
14) Install the 5th needle bearing and 5th drive
gear.
(B)
(A) 5th needle bearing
(B) 5th drive gear
15) Install the 5th baulk ring.
16) Install the 5th-6th hub.
(1) Set the 5th-6th hub to main shaft paying at-
tention to the installing direction.
(A) Main shaft
(B) 5th-6th hub
(C) 5th drive gear
(A)
MT-00568
MT-00569
(A)
(B)
(C)
MT-00570