Subaru Legacy 2005 Service Manual page 2696

MANUAL TRANSMISSION AND DIFFERENTIAL
6. Manual Transmission As-
sembly
A: REMOVAL
1) Set the vehicle on a lift, then fully open the front
hood and support with stay.
NOTE:
Set the hood stay to its specified hole.
2) Disconnect the ground cable from battery.
3) Remove the collector cover.
4) Remove the air intake chamber.
<Ref. to IN(H6DO)-7, REMOVAL, Air Intake Cham-
ber.>
5) Remove the air cleaner case.
<Ref. to IN(H6DO)-5, REMOVAL, Air Cleaner
Case.>
6) Lift-up the vehicle and remove the under cover.
7) Remove the front wheels.
8) Remove the universal joint. <Ref. to PS-22, RE-
MOVAL, Universal Joint.>
9) Disconnect the engine harness connectors, and
then remove the engine hanger rear.
(A) Engine harness connectors
(B) Engine hanger rear
Manual Transmission Assembly
(B)
(A)
MT-01302
6MT-34
10) Disconnect the ground cable at upper side of
transmission case and body.
11) Remove the starter assembly. <Ref. to
SC(H4SO 2.0)-6, REMOVAL, Starter.>
12) Remove the operating cylinder from transmis-
sion.
NOTE:
Hang the removed operating cylinder with wire or
etc.
13) Remove the pitching stopper and remove the
pitching stopper bracket.
MT-01266
MT-01267
MT-01268