Subaru Legacy 2005 Service Manual page 2804

CLUTCH SYSTEM
• RHD model
(9)
(10)
(8)
(7)
T2
T3
T1
(1) Stopper
(2) Clutch pedal pad
(3) Clutch pedal
(4) Bushing C
(5) Clutch clevis pin
(6) Assist rod A
(7) Clip
(8) Assist spring
(9) Assist bushing
C: CAUTION
• Wear work clothing, including a cap, protective
goggles and protective shoes during operation.
• Remove contamination including dirt and corro-
sion before removal, installation or disassembly.
• Keep the disassembled parts in order and pro-
tect them from dust and dirt.
• Before removal, installation or disassembly, be
sure to clarify the failure. Avoid unnecessary re-
moval, installation, disassembly and replacement.
• Be careful not to burn yourself, because each
part on the vehicle is hot after running.
• Use SUBARU genuine fluid, grease etc. or
equivalent. Do not mix fluid, grease, etc. with that of
another grade or from other manufacturers.
• Be sure to tighten fasteners including bolts and
nuts to the specified torque.
General Description
(5)
(6)
(4)
(18)
(1)
(11)
(12)
(10) Assist rod B
(11) Spring A
(12) Rod S
(13) Bushing B
(14) Clip
(15) Clutch switch
(16) Spacer
(17) Bushing
(18) Clutch pedal bracket
(15)
(14)
(13)
T2
(4)
(17)
(4)
• Place shop jacks or rigid racks at the specified
points.
• Apply grease onto sliding or revolution surfaces
before installation.
• Before installing O-rings or snap rings, apply suf-
ficient amount of fluid to avoid damage and defor-
mation.
• Before securing a part in a vise, place cushioning
material such as wood blocks, aluminum plate or
cloth between the part and the vise.
• Keep fluid away from the vehicle body. If any flu-
id contacts the vehicle body, immediately flush the
area with water.
CL-14
(16)
(20)
(19)
(17)
(1)
(2)
(3)
(19) Clutch pedal catcher
(20) Bracket (Clutch pedal catcher)
⋅
Tightening torque: N m (kgf-m, ft-lb)
T1: 8 (0.8, 5.8)
T2: 18 (1.8, 13.0)
T3: 30 (3.1, 22.4)
T2
CL-00291