Subaru Legacy 2005 Service Manual page 2635

5) Remove the outer snap ring. Then remove the
oil squeeze plate and straight pin.
( B )
(A) Snap ring
(B) Oil squeeze plate
6) Remove the snap ring.
(A) Snap ring
7) Using a press and ST, remove the ball bearing.
NOTE:
Remove the inner snap ring before pressing.
ST 498077000 REMOVER
S T
8) Remove the oil seal from input shaft holder.
D: ASSEMBLY
1) Install the ball bearing onto input shaft.
NOTE:
Place the snap ring between input shaft gear and
ball bearing beforehand. Use the table at 8) as a
guide in selecting a suitable snap ring.
Input Shaft Assembly
( A )
MT-00229
( A )
MT-00230
MT-00231
5MT-73
MANUAL TRANSMISSION AND DIFFERENTIAL
ST1 899580100 INSTALLER
ST2 399513600 INSTALLER
2) Install the snap ring on input shaft.
(A) Snap ring
3) Inspect the clearance between ball bearing and
snap ring. <Ref. to 5MT-74, INSPECTION, Input
Shaft Assembly.>
4) Install the straight pin and oil squeeze plate to in-
put shaft.
(A) Straight pin
(B) Oil squeeze plate
5) Install the snap ring.
6) Install the oil seal into input shaft holder.
NOTE:
Apply a coat of grease to sealing lips before install-
ing oil seal.
ST1
ST2
MT-00232
( A )
MT-00230
(A)
(B)
MT-00234