Subaru Legacy 2005 Service Manual page 2144

AUTOMATIC TRANSMISSION
7) Install the converter case to transmission case.
<Ref. to 4AT-102, INSTALLATION, Converter
Case.>
8) Insert the inhibitor switch and transmission con-
nector to stay.
(B)
(A) Transmission connector
(B) Inhibitor switch connector
9) Install the oil cooler pipe. <Ref. to 4AT-70, IN-
STALLATION, ATF Cooler Pipe and Hose.>
10) Install the oil charge pipe with a O-ring. <Ref. to
4AT-80, INSTALLATION, Oil Charge Pipe.>
11) Insert the input shaft while rotating it lightly by
hand, and then check the protrusion amount.
Normal protrusion A:
50 — 55 mm (1.97 — 2.17 in)
A
12) Install the torque converter clutch assembly.
<Ref. to 4AT-81, INSTALLATION, Torque Convert-
er Clutch Assembly.>
13) Install the transmission assembly into vehicle.
<Ref. to 4AT-42, INSTALLATION, Automatic
Transmission Assembly.>
Front Differential Assembly
C: DISASSEMBLY
1. DIFFERENTIAL CASE ASSEMBLY
1) Remove the taper roller bearing using ST and
press.
ST 498077000
(A)
AT-01351
2) Secure the case in a vise, remove the hypoid
driven gear tightening bolts, and then separate the
hypoid driven gear into case (RH) and case (LH).
3) Pull out the straight pin and shaft, and then re-
move the differential bevel gear, washer and differ-
ential bevel pinion.
AT-03204
4AT-116
REMOVER
(C)
(A) Hypoid driven gear
(B) Differential case (RH)
(C) Differential case (LH)
(A) Differential case (RH)
AT-00216
(A)
(B)
AT-00217
(A)
AT-00218