Subaru Legacy 2005 Service Manual page 2352

Hide thumbs Also See for Legacy 2005:
Table of Contents

Advertisement

AUTOMATIC TRANSMISSION
46) Remove the transmission mounting bolt (lower
side).
47) Remove the transmission.
NOTE:
• Turn the engine support assembly from the vehi-
cle under body to the left (to shorten the engine
support length), and lower the rear of the engine for
easy disassembly.
• Be careful not to allow breather pipe and etc. to
touch the vehicle body when detaching the auto-
matic transmission assembly by pulling it back-
ward.
B: INSTALLATION
1) Install the ST to converter case.
ST 498277200
STOPPER SET
2) Install the transmission onto engine.
(1) Lift up the transmission gradually using a
transmission jack.
(2) Align the transmission to engine.
3) Install the engine mounting bolt (lower side).
Tightening torque:
50 N
m (5.1 kgf-m, 36.9 ft-lb)
Automatic Transmission Assembly
AT-00108
ST
AT-00103
5AT-42
4) Install the transmission rear crossmember.
Tightening torque:
70 N
m (7.1 kgf-m, 51.6 ft-lb)
5) Take off the transmission jack.
6) Lower the vehicle.
7) Install the engine mounting bolt (upper side).
Tightening torque:
50 N
m (5.1 kgf-m, 36.9 ft-lb)
8) Remove the ST from converter case.
ST 498277200
STOPPER SET
9) Install the starter. <Ref. to SC(H4SO 2.0)-6, IN-
STALLATION, Starter.>
10) Install the torque converter to drive plate.
(1) Install the bolts which hold torque converter
to drive plate.
(2) Install all four bolts by rotating the crank pul-
ley a little at a time.
(3) Install the service plug hole.
Tightening torque:
25 N
m (2.5 kgf-m, 18.4 ft-lb)
11) Remove the ST and install the pitching stopper
bracket.
Tightening torque:
41 N
m (4.2 kgf-m, 30.2 ft-lb)
AT-01377
AT-01369

Advertisement

Table of Contents
loading

Table of Contents