Subaru Legacy 2005 Service Manual page 2413

(3) Make sure the rear end of drive pinion shaft
is engaged to the spline of reduction driven
gear.
(A)
(A) Drive pinion shaft
(4) Protect the input clutch shaft with a cloth,
and rotate to engage the spline of input clutch
and rear carrier using pliers.
NOTE:
Work with pressing the oil pump cover.
(A) Cloth
(5) Combine the oil pump cover with transmis-
sion main case.
Tightening torque:
⋅
41 N m (4.2 kgf-m, 30.2 ft-lb)
23) Install the center differential carrier. <Ref. to
5AT-78, INSTALLATION, Center Differential Carri-
er.>
24) Install the reduction driven gear. <Ref. to 5AT-
76, INSTALLATION, Reduction Driven Gear.>
AT Main Case
AT-02092
(A)
AT-02046
AT-01976
25) Install the extension case and intermediate
case. <Ref. to 5AT-71, INSTALLATION, Extension
Case and Intermediate Case.>
26) Install the control valve body. <Ref. to 5AT-58,
INSTALLATION, Control Valve Body.>
27) Install the converter case assembly into trans-
mission case assembly. <Ref. to 5AT-82, INSTAL-
LATION, Converter Case.>
28) Install the air breather hose. <Ref. to 5AT-68,
INSTALLATION, Air Breather Hose.>
29) Install the ATF filter pipe. <Ref. to 5AT-60, IN-
STALLATION, ATF Filter.>
30) Install the oil charge pipe with a O-ring. <Ref. to
5AT-69, INSTALLATION, Oil Charge Pipe.>
31) Install the torque converter assembly. <Ref. to
5AT-70, INSTALLATION, Torque Converter As-
sembly.>
32) Install the transmission assembly into vehicle.
<Ref. to 5AT-42, INSTALLATION, Automatic
Transmission Assembly.>
33) Perform the Clear Memory 2. <Ref. to 5AT(di-
ag)-19, CLEAR MEMORY MODE, OPERATION,
Subaru Select Monitor.>
34) Perform the inspection with driving the vehicle
at the end of repair work, and make sure there is no
faulty as below;
• Excessive shift shock
• Oil leakage from transmission body and etc.
• Occurrence of noise caused by interference etc.
NOTE:
If excessive shift shock is felt, execute the advance
operation of learning control. <Ref. to 5AT(diag)-
23, PROCEDURE, Learning Control.>
C: DISASSEMBLY
1. INPUT CLUTCH PACK ASSEMBLY
1) Remove the front sun gear.
5AT-103
AUTOMATIC TRANSMISSION
AT-02007