Subaru Legacy 2005 Service Manual page 2157

38) Install the thrust needle bearing in proper direc-
tion.
(B)
(A) High clutch hub
(B) Thrust needle bearing
(C) Upside
(D) Downside
(E) Outside
39) Install the high clutch assembly.
(A)
(A) High clutch and reverse clutch ASSY
40) Adjust total end play. <Ref. to 4AT-108, AD-
JUSTMENT, Oil Pump Housing.>
41) Install the thrust needle bearing in proper direc-
tion.
(A)
(A) High clutch and reverse clutch ASSY
(B) Thrust needle bearing
(C) Upside
(D) Downside
(E) Outside
AT Main Case
(C)
(E)
(D)
(A)
AT-02219
AT-00235
(C)
(B)
(E)
(D)
AT-02220
42) Install the oil pump housing assembly with a
new gasket. <Ref. to 4AT-104, Oil Pump Housing.>
43) Install the converter case assembly into trans-
mission case assembly. <Ref. to 4AT-102, IN-
STALLATION, Converter Case.>
44) Insert the inhibitor switch connector and trans-
mission connector to stay.
45) Install the air breather hose. <Ref. to 4AT-79,
INSTALLATION, Air Breather Hose.>
(A) Transmission connector
(B) Inhibitor switch connector
46) Install the oil cooler pipe. <Ref. to 4AT-70, IN-
STALLATION, ATF Cooler Pipe and Hose.>
47) Install the oil charge pipe with a O-ring. <Ref. to
4AT-80, INSTALLATION, Oil Charge Pipe.>
48) Insert the input shaft while rotating it lightly by
hand, and then check the protrusion amount.
Normal protrusion A:
50 — 55 mm (1.97 — 2.17 in)
49) Install the torque converter clutch assembly.
<Ref. to 4AT-81, INSTALLATION, Torque Convert-
er Clutch Assembly.>
50) Install the transmission assembly into vehicle.
<Ref. to 4AT-42, INSTALLATION, Automatic
Transmission Assembly.>
4AT-129
AUTOMATIC TRANSMISSION
(B)
(A)
A
AT-01351
AT-03204