Subaru Legacy 2005 Service Manual page 2022

CONTROL SYSTEMS
8) Secure the reverse check cable to clip of stay.
NOTE:
Install the reverse check cable to upper side of
stay.
(A)
(A) Reverse check cable
(B) Clip
9) Install the rear exhaust pipe and muffler. <Ref. to
EX(H6DO)-7, INSTALLATION,
Pipe.> <Ref. to EX(H6DO)-9, INSTALLATION,
Muffler.>
10) Lower the vehicle.
11) Install the front cover assembly.
12) Install the console box. <Ref. to EI-53, INSTAL-
LATION, Console Box.>
C: INSPECTION
1) Make sure the slider moves smoothly. If it does
not move, adjust the reverse check cable or check
the slider for damage. <Ref. to CS-54, ADJUST-
MENT, Reverse Check Cable.>
2) Check that the gear is shift to reverse, when the
slider is pulled up. If the gear is not shift to reverse,
adjust the reverse check cable. <Ref. to CS-54,
ADJUSTMENT, Reverse Check Cable.>
3) Check that the gear is not shift to reverse, when
the slider is not pulled up. If the gear is shift to re-
verse, adjust or replace the reverse check cable.
<Ref. to CS-54, ADJUSTMENT, Reverse Check
Cable.>
D: ADJUSTMENT
1) Lift-up the vehicle.
2) Remove the under cover.
3) Remove the rear exhaust pipe and muffler.
<Ref. to EX(H6DO)-7, REMOVAL, Rear Exhaust
Pipe.> <Ref. to EX(H6DO)-9, REMOVAL, Muffler.>
4) Remove the crossmember. <Ref. to 6MT-32,
REMOVAL, Transmission Mounting System.>
Reverse Check Cable
(B)
CS-00243
Rear Exhaust
5) Remove the snap pin and washer, and then sep-
arate the reverse check cable from reverse check
lever.
(B)
(A) Snap pin
(B) Washer
(C) Reverse check cable
6) Move the transmission to the right side, then re-
move the stay bolt and reverse check cable.
NOTE:
If the transmission is not moved, stay bolt may con-
tact the body. It will cause damage.
(A)
(B)
(A) Stay
(B) Stay bolt
7) Adjust the length between end of cable plate and
reverse check cable to 84 mm (3.31 in), and then
tighten the lock nut.
Tightening torque:
⋅
6 N m (0.6 kgf-m, 4.4 ft-lb)
(A) 84 mm (3.31 in)
CS-54
(A)
(C)
CS-00220
CS-00245
(A)
CS-00242