Subaru Legacy 2005 Service Manual page 2368

AUTOMATIC TRANSMISSION
17.Control Valve Body
A: REMOVAL
1) Set the vehicle on a lift.
2) Disconnect the ground cable from battery.
3) Lift-up the vehicle.
4) Clean the transmission exterior.
5) Remove the ATF drain plug to drain ATF.
CAUTION:
Directly after the vehicle has been running, the
ATF is hot. Be careful not to burn yourself.
6) Tighten the ATF drain plug.
NOTE:
Use a new gasket.
Tightening torque:
⋅
25 N m (2.5 kgf-m, 18.4 ft-lb)
7) Remove the oil pan.
CAUTION:
Be sure to prevent the entering of dust and oth-
er foreign matters into oil pan.
8) Remove the magnet.
9) Clean the magnet.
10) Completely remove the remaining liquid gasket
on the transmission case and oil pan.
11) Disconnect the control valve connector and
front vehicle speed sensor connector.
(A)
(A) Control valve connector
(B) Front vehicle speed sensor connector
Control Valve Body
AT-01959
(B)
AT-01956
5AT-58
12) Remove the control valve body.
NOTE:
Replace the control valve body as assembly, be-
cause it is a non-disassemble part.
B: INSTALLATION
1) Check the control valve body for dust and other
foreign matters.
2) Install the control valve body to transmission by
equally tightening the bolts.
Tightening torque:
⋅
8 N m (0.8 kgf-m, 5.9 ft-lb)
(1)
(2)
(1)
(2)
(2)
(2)
(2)
(1) 58 mm (2.28 in)
(2) 65 mm (2.56 in)
3) Connect the control valve connector.
(A)
(A) Control valve connector
(B) Front vehicle speed sensor connector
AT-01957
(1)
(1)
(1)
(1)
(1)
(1)
AT-01958
(B)
AT-01956