Subaru Legacy 2005 Service Manual page 2806

CLUTCH SYSTEM
2. Clutch Disc and Cover
A: REMOVAL
1. 5MT EC, EK AND KA MODEL
1) Remove the transmission assembly from vehi-
cle. <Ref. to 5MT-30, REMOVAL, Manual Trans-
mission Assembly.>
2) Insert the ST to flywheel.
ST 499747100 CLUTCH DISC GUIDE
( A )
(A) Dual mass flywheel
3) Remove the clutch cover and clutch disc.
NOTE:
• Take care not to allow oil on the clutch disc fac-
ing.
• Do not disassemble the clutch cover or clutch
disc.
• Be sure to put alignment marks on the flywheel
and clutch cover before removing clutch cover.
2. 5MT KS, K4, TURBO MODEL AND 6MT
MODEL
1) Remove the transmission assembly from vehi-
cle. <Ref. to 5MT-30, REMOVAL, Manual Trans-
mission Assembly.> <Ref. to 6MT-34, REMOVAL,
Manual Transmission Assembly.>
Clutch Disc and Cover
2) Install the ST to flywheel.
ST 499747100
3) Remove the clutch cover and clutch disc.
NOTE:
• Take care not to allow oil on the clutch disc fac-
ing.
ST
• Do not disassemble the clutch cover or clutch
CL-00112
disc.
B: INSTALLATION
1. 5MT EC, EK AND KA MODEL
1) Insert the ST into clutch disc, and install on the
flywheel by inserting the ST end into pilot bearing.
NOTE:
When installing the clutch disc, be careful to its di-
rection.
ST 499747100
CL-00113
2) Install the clutch cover on flywheel and tighten
bolts to the specified torque.
NOTE:
• When installing the clutch cover on the flywheel,
position the clutch cover so that there is a gap of
120° or more between the paint marks "
flywheel and clutch cover. (the paint marks "
indicate the directions of residual unbalance.)
• Note the front and rear of the clutch disc when in-
stalling.
CL-16
CLUTCH DISC GUIDE
( A )
(A) Clutch cover
CLUTCH DISC GUIDE
(A)
(A) Flywheel side
S T
CL-00011
(A)
ST
CL-00282
" on the
"