10) Install the snap ring of reverse brake.
11) Perform the clearance check of reverse brake.
(1) Measure the clearance between retainer
plate and snap ring using thickness gauge.
Specification:
0.7 — 1.1 mm (0.028 — 0.043 in)
(2) If the clearance is out of specification, select
a suitable retainer plate from following table and
assemble it.
Retainer plate
Part No.
31567AB100
31567AB170
31567AB180
31567AB190
31567AB200
12) Install the direct clutch assembly.
AT Main Case
AT-01998
AT-02372
Thickness mm (in)
4.2 (0.165)
4.4 (0.173)
4.6 (0.181)
4.8 (0.189)
5.0 (0.197)
AT-01997
5AT-101
AUTOMATIC TRANSMISSION
13) Install the high & low reverse clutch assembly.
14) Install the thrust needle bearing of high & low
reverse clutch.
15) Install the middle & rear sun gear assembly.
AT-01996
AT-01995
AT-01994