Subaru Legacy 2005 Service Manual page 2731

19.Main Shaft Assembly
A: REMOVAL
1) Remove the manual transmission assembly
from vehicle. <Ref. to 6MT-34, REMOVAL, Manual
Transmission Assembly.>
2) Prepare the transmission for overhaul. <Ref. to
6MT-40, Preparation for Overhaul.>
3) Remove the oil pipe, neutral position switch,
back-up light switch and harness. <Ref. to 6MT-42,
REMOVAL, Oil Pipe.> <Ref. to 6MT-45, REMOV-
AL, Neutral Position Switch.> <Ref. to 6MT-43, RE-
MOVAL, Back-up Light Switch.>
4) Remove the extension case. <Ref. to 6MT-47,
REMOVAL, Extension Case.>
5) Remove the transfer driven gear. <Ref. to 6MT-
58, REMOVAL, Transfer Driven Gear.>
6) Remove the center differential. <Ref. to 6MT-60,
REMOVAL, Center Differential.>
7) Remove the oil pump. <Ref. to 6MT-61, RE-
MOVAL, Oil Pump.>
8) Remove the transmission case. <Ref. to 6MT-
64, REMOVAL, Transmission Case.>
9) Remove the striking rod.
10) Shift to 4th gear position using a screwdriver.
(A)
(A) 3rd-4th shift rod
11) Remove the reverse idler holder.
(A)
(A) Reverse idler holder
12) Remove all of the checking ball plug, gasket,
checking ball spring, plunger and ball from adapter
plate.
Main Shaft Assembly
NOTE:
Use a new gasket.
(A)
13) Remove the bolts and gasket which install the
reverse idler shaft.
MT-00543
14) Push the main shaft assembly, driven gear as-
sembly, reverse idler gear and each shifter fork to
remove them from adapter plate at a time.
NOTE:
A helper is required to perform this work.
MT-00544
6MT-69
MANUAL TRANSMISSION AND DIFFERENTIAL
(B)
(C)
(D)
(A) Checking ball plug
(B) Gasket
(C) Checking ball spring
(D) Plunger
(E) Ball
(A)
(B)
(C)
(E)
MT-00545
MT-00546