Subaru Legacy 2005 Service Manual page 2154

AUTOMATIC TRANSMISSION
Retaining plate
Part No.
31667AA420
31667AA320
31667AA330
31667AA340
31667AA350
31667AA360
31667AA370
31667AA380
18) Install the leaf spring of low & reverse brake.
(A) Leaf spring
19) Install the 2-4 brake piston and 2-4 brake re-
tainer by aligning the holes of 2-4 brake retainer
and hole of transmission case.
(B)
(A) 2-4 brake piston
(B) 2-4 brake piston retainer
20) Install 2-4 brake piston return spring to trans-
mission case.
AT Main Case
Thickness mm (in)
3.8 (0.150)
4.1 (0.161)
4.4 (0.173)
4.7 (0.185)
5.0 (0.197)
5.3 (0.209)
5.6 (0.220)
5.9 (0.232)
(A)
AT-00293
(A)
AT-00287
AT-00286
21) Position the snap ring in transmission. Using
the ST, press-fit the snap ring into specified place.
ST 498677100
S T
22) Install the planetary gear and low clutch as-
sembly to transmission case.
Install carefully while rotating the low clutch and
planetary gear assembly slowly paying special at-
tention not to damage the seal ring.
23) Place the dish plate, driven plate, drive plate
and retaining plate neatly in this order on surface
table.
24) Set the dial gauge to clutch, and read its scale.
NOTE:
The value, which is read in the gauge at this time, is
zero point.
25) Scale and record the weight "Z" of a flat board
which will be put on retaining plate.
NOTE:
• Use a stiff board which does not bend against
load as a flat board to be put on retaining plate.
• Use a flat board of its weight less than 10.2 kg
(22.5 lb).
4AT-126
COMPRESSOR
AT-00289
AT-00255