Subaru Legacy 2005 Service Manual page 2785

NOTE:
• Remove the remaining gasket on edge surface
with scraper, since the adapter plate is base point
of measurement.
• Do not place the height gauge on shaded area in
the figure during the measurement.
4) Press the reverse sleeve to reverse side idler
gear No. 2, then measure "T".
T
(A) Reverse idler gear No. 2.
(A)
(A) Reverse idler gear No. 2.
Shifter Fork and Rod
NOTE:
• Set the indicator of height gauge near measuring
object, then lock the dial (1) as shown in the figure.
Turn dial (2) to set the indicator to edge surface of
reverse sleeve side.
• Measure five points of the sleeve turning every
approx. 72°. Round off each two upper and lower
measurement value. Use the remaining middle val-
ue as measurement value.
MT-00583
5) According to measurement, calculate the re-
verse sleeve neutral position. Select the fork rod,
which applies to the calculated value from following
calculation formula.
(A)
Calculation formula: T + 4.8 mm (0.189 in)
MT-00715
T = Thickness
MT-00716
6MT-123
MANUAL TRANSMISSION AND DIFFERENTIAL
T + 4.8 mm (0.189 in)
mm (in)
33.50 — 33.80
(1.3189 — 1.3307)
33.80 — 34.10
(1.3307 — 1.3425)
34.10 — 34.40
(1.3425 — 1.3543)
(2)
(1)
MT-00585
Lot No. (Mark)
32816AA110 (1)
32816AA130 (None)
32816AA140 (2)